Has the battery in the main unit run down? Replace it with a new one. The main unit may still have a charge. Put the battery in backwards to short the unit then install properly and do all clear operation.
|Published (Last):||9 February 2015|
|PDF File Size:||13.28 Mb|
|ePub File Size:||5.92 Mb|
|Price:||Free* [*Free Regsitration Required]|
No measurement is done on the VELO5. The upper display always shows the Current Speed. Power Saving Function If the main unit does not receive a signal after about 10 minutes, the main unit enters Power Saving Mode and displays the clock count only. Data Reset When a screen with the and the measured data will return to zero. However, the Odometer total distance and Clock do not return to zero. If mph has been selected, it becomes hour clock.
If they become rusty, it will cause speed detection error. Troubleshooting Has the battery in the main unit run down? Replace it with a new one. First, short-circuit the contact of the main unit a few times with a piece of metal.
If current speed appears, the main unit is working fine and the cause should be attributed to the bracket or the sensor.
Is the clearance between the sensor and the magnet too large? Re-adjust the positions of the magnet and the sensor. The clearance should be less than 5mm. Replace the bracket and sensor set with a new one. Is there anything sticking on the contact of the main unit or the bracket? Current speed disappears when using in the rain.
Wipe any water or dirt from the contacts and apply a water repellent silicon grease. Do not apply standard grease, as it may cause damage to the bracket. It differs from the actual consumed calorie.
Cateye CC-VL500 User Manual
Cateye VELO 5 Manuals & User Guides
Product Quick Start Manuals
Cateye Velo5 CC-VL510 User Manual